User manual

101

USER MANUAL

5.11 Output Settings

5.11.1 Activate Output Relay to Stay On for a Specific Time

To activate the output relay, you can send a text command via SMS specifying the

number of seconds the output should stay on to the unit. It is possible to set up to

maximum of 65,535 seconds

Text Command:

*RLY[N]#XXXXX

N stands for Output number 1 - 3

XXXXX stands for 5 digits value: The number of seconds (00000-65535)

For example, assume you want to turn on the output relay number 2 for 1 hour, you

would send the following SMS message to the unit.

*RLY2#03600

Return Message

RLY2#=03600

Sending the following SMS Message to unit would mean turn off the output relay

number 1.

*RLY1#00000

5.11.2 Enable/Disable the SMS Report when the Relay has turned off

The system has the function to send a SMS to the user when the relay has

turned off. It is possible to enable or disable this function by sending the

following SMS command to the unit.

Text Command:

*RLR[N]#X

N stands for Output number 1 – 3

X stands for ON (1) or OFF (0) value

Example:

When *RLR1#1 (Default) is applied, means when Relay 1 has turned off, it will send

a message to the programmable administrator number 1.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com