User manual

WT
-
101
0
C2
USER MANUAL
5.10.4Editing the Inputs Alert Messages (Up to 50 Characters)
The Input Alert Message can be edited and programmed up to 50 characters. You can
change the displayed text by sending the following commands by SMS message to the
unit.
Note: Only support normal abc/ABC English text, no special characters.
Text Command:
*USE[N]#XXXXXX…
N stands for Input number 1 – 3
XXXXXX… stands for alert message content
Example:
If you want the alert message to display “Garage Opened!” when input 1 triggered;
you would send the following SMS message to the unit.
*USE1#Garage Opened!
Return Message
USE1=Garage Opened!
5.10.5Turning the Audible Siren functions On/Off when Inputs Triggered
The system has the function to sound the connected audible siren when input triggered.
This output is available on the connection PIN4 and ground on the main board. To turn
On/Off this function, you can send the following SMS command to the unit.
Text Command:
*ALM[N]#X
N stands for Input number 1 – 3
X stands for ON (1) or OFF (0) value
When *ALM1#1 is applied, means audible alarm will sound when Input 1 triggered.
When *ALM1#0 (Default) is applied, means audible alarm will not sound when Input
1 triggered.
To turn on this function for input 1, you would send *ALM1#1 SMS command to the
unit.
Return Message
ALM1-ON
37
WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD