User manual

WT
-
101
0
C2
USER MANUAL
*INR[N]#X
N stands for Input number 1 – 3
X stands for ON (1) or OFF (0) value
Example:
When *INR1#1 is applied, means when Input 1 has triggered (Open/High Pulse), it
will send an alert message to administrator/central station number 1.
When *INR1#0 (Default) is applied, means when Input 1 has triggered (Open/High
Pulse), it will not send any alert message to administrator/central station number 1.
To enable this function for input 1, you would send *INR1#1 SMS command to the
unit.
Return Message
INR1-ON
5.10.3 Enable/Disable the function of generating an Alert Message when
Inputs Triggered (Close) upon Low Pulse
The system has the function to send alert message to the user in the event of input
triggered. It is possible to enable or disable this function by sending the following SMS
command to the unit.
Text Command:
*INP[N]#X
N stands for Input number 1 – 3
X stands for ON (1) or OFF (0) value
Example:
When *INP1#1 is applied, means when Input 1 has triggered (Close/Low Pulse), it
will send an alert message to administrator/central station number 1.
When *INP1#0 (Default) is applied, means when Input 1 has triggered (Close/Low
Pulse), it will not send any alert message to administrator/central station number 1.
To enable this function for input 1, you would send *INP1#1 SMS command to the
unit.
Return Message
INP1-ON
36
WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD