User manual

101

USER MANUAL

When *DTC?#1 is applied, it will dial the programmable administrator/central station

number at the programmed report time interval.

When *DTC?#0 (Default) is applied, it will not dial the administrator/central station

number.

To enable this function, you would send *DTC?#1 SMS command to the unit.

Return Message

DTCALL-ON

5.10 Input Settings

5.10.1 Enable/Disable the function of Dialing the programmable Administrator

/Central Station number when Input Triggered

To program the unit to dial the programmed administrator/central station number

when input triggered, you can send the following SMS command to the unit.

Text Command:

*INC[N]#X

N stands for Input number 1 - 3

X stands for ON (1) or OFF (0) value

When *INC1#1 is applied, it will dial the programmable administrator/central station

number when Input 1 triggered.

When *INC1#0 (Default) is applied, it will not dial the administrator/central station

number when Input 1 triggered.

To enable this function for input 1, you would send *INC1#1 SMS command to the

unit.

Return Message

INC1CALL-ON

5.10.2 Enable/Disable the function of generating an Alert Message when

Inputs Triggered (Open) upon High Pulse

The system has the function to send alert message to the user in the event of input

triggered. It is possible to enable or disable this function by sending the following SMS

command to the unit.

Text Command:

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com