User manual

101

USER MANUAL

5. WT-1010C2 Configuration Instructions (Via SMS)

You can program the WT-1010C2 via SMS commands using your phone. Any

programming command sent by SMS must be in CAPITAL letters. The fields between

square brackets are parameters; do NOT enter the square brackets. When you send a

command, you will receive the answer for the first time even if your GSM number is

not in the administrator list. This happens because the WT-1010C2 recognizes any

GSM number as administrator and answers to it.

Warning: The administrator number must be program into the WT-1010C2 unit first via voice

mode in order to use SMS programming mode.

5.1 Setting the Recipient that will receive Alert Messages

The unit can send text alerts to 1 or all 8 of the programmed administrator’s mobile

phone numbers and this function can be changed at any time by sending the following

commands by SMS message to the unit.

Text Command:

*SECT#XXXXXXXX

XXXXXXXX stands for 8 digits value: ON (1) or OFF (0) for the 8 Administrators

Example:

When *SECT#11110000 is applied, means only administrator 1, 2, 3 and 4 will

receive alert messages.

Return Message

*SECT#11110000

Note: You can only put 1 in the first 4 digits of the text command if there are only

phone numbers stored in #TEL1, #TEL2, #TEL3 and #TEL4. The rest should be 0.

When *SECT#00000000 is applied, means no SMS report.

5.2 Setting the Access Control for Administrator

Note: It is advised that the owner should set the system to allow programming

access for administrators only after programmed the Administrator numbers.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com