User manual

WT
-
101
0
C2
USER MANUAL
11) Setting the Burst On and Burst Off time of DTMF tones
The Burst ON and Burst OFF timing of the sending Contact-ID can be adjust with
the below command. To set the Burst on and Burst off time, press *37* to
proceed.
DTMF BURST TIME
ON: OFF:
DTMF BURST TIME
ON:3 OFF:1
Example: To set the Burst On time at 50~60ms (3)
and Burst Off time at 10~20ms (1)
Simply press 31#
DTMF BURST TIME
ON:3 OFF:1 OK
Note: Value 1 stands for 10~20ms
Value 2 stands for 20~40ms
Value 3 stands for 50~60ms
Value 4 stands for 60~80ms
Value 5 stands for 80~100ms
12)
Setting the Auto Test Report Time Interval
The system has the function of sending the test report to the central station at
the programmable time interval. The time is entered in 24 Hour format.
To set the auto test report time interval, you can press *17* to proceed.
DSTM: : :
DSTM: 12 : 00 : 00
Example: To set the auto test report time at 12.00pm
17
WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD