User manual

WT
-
101
0
C2
USER MANUAL
The WT-1010C2 can be programmed manually by a connected normal telephone.
Note: Before commencing programming it is advisable to read the below
programming setting instructions thoroughly. To start with programming, user must
plug-in a normal single line phone to TEL1 (Port 1)
1)
Enter Programming Mode
Pick up the handset or press hands free, press **123456# to enter
programming mode. If the password has entered correctly, you should see
“HAND FREE…” displayed on WT-1010C2 screen.
Now you may proceed with programming settings.
When pick up the handset
ENTER
SETTING…
ENTER OK
SETTING…
Connect to TEL1
4.1 Introduction
4. WT-1010C2 Configuration Instructions (Via Voice)
Password entered correctly
11
WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD