User manual

101

USER MANUAL

When the terminal is ready to use, it will display as below

WT-1010

Battery

Functional

Power

Signal

3.5) Dialing a number from the attached telephone set

Connect to TEL1

After the GSM module is connected to the GSM network, an attached fixed line phone

can be used to make calls. If you pick up the phone, you will hear a dial tone. Simply

dial the number you want to call (as if you are dialing from a normal fixed line

phone). You can also dial the WT-1010C2 unit’s phone number from another phone,

and its attached phone will ring as a normal landline phone would. If there is a busy

tone on the attached telephone set, either the line you are calling is busy, or the

GSM communicator is busy with previous communication at that moment (for

example data transfer to the monitoring station).

Note: Some telephone sets are sensitive to the GSM radio signal. For this reason

you may hear a characteristic noise in the telephone receiver when calling. If the

noise is disturbing, change the location of the phone set (try to keep it as far as

possible from the WT-1010C2 unit antenna). Usually it is possible to find a suitable

location for the phone with minimal level of interference.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com