User manual

9
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
Attention: The color coding on the above indicators will be identical with the actual DB-
15 connector cable (Female Type)
4.4 Descri
p
tion
1. Antenna: connect the antenna to the GSM module; place the antenna as far as
possible from the WT-1010C2 and do not leave any coiling of the antenna cable to
avoid radiant interference
2. SIM Card: disable the PIN code and set it to 1234 (default)
For Transmitter Mode (Data or SMS):
as with any transmitter, it requires an
identifier, receiver telephone numbers, etc (refer to the complete information on
Programming page)
3. Line Input: connect the line input to the PSTN or ISDN network.
4. Outputs (Back-Up Mode): connect the RS232 DB15 to additional remote
controlling outputs.
5. Alarm Input: connect the input to output of the Alarm Panel / Control Panel.
6. Power Supply: connect to a 12V power supply
7. Operating State: Approximately 20s after power up check the operating state
indicated by the Power LED: the LED is steady during power up phase, and then
blinks when the connection to the GSM network is established. The Signal
indicator LED will stay lit whenever there is signal.
4.3 Wirin
g
Dia
g
ram B
(
View of DB-15 Cable Connector Female T
yp
e
)