User manual

7
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
7. It is possible to arm/disarm the unit remotely via remote control, SMS or phone call.
Alternatively, it also can connect to the basic telephone to perform arm/disarm.
8. Three digital inputs: The system has the function to send SMS and call to the user
in the event of input triggered. For example, Zone 3 connected to an electric door,
when there is intruder or the electric door is open illegally, WT-1010C2 will receive
short circuit impulse on Zone 3 and automatically sends a signal to the pre-set
number and notify the owner.
9. Three remote control outputs: These open collector outputs (that can sink max
300ma per output) can be turned on and off remotely through a SMS or phone call.
Remote control will be reachable by sending a SMS or phone call with a certain
command. For example SMS/Call in to switch on lighting, air conditional, generator,
sensor or other equipment.
10. Standby rechargeable battery to prevent power failure or electricity cut off by
intruder. The GSM will function as normal when no electricity supply. LCD display to
check the GSM signal strength and battery capacity
11. Low power consumption - uses 30mA while in idle state and 260mA when
transmitting an alarm
12. Wall mounting enclosure available: The WT-1010C2 units can be installed inside the
alarm panel or inside its own wall mount enclosure.