User manual

40
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
Note: Both SPK and MIC volume level range from 1 – 4 (Default: 1). Adjust the speaker and
microphone volume to compatible with your alarm panel
To check the software and hardware version of WT-1010C2 unit, you can press *13* to
proceed.
The information will be displayed on screen
Press # to turn back
To inquire all the programmed administrator, you can send the following SMS command
to the unit.
Text Command:
*ADM?#
Example of Return Message
1: 13256997049
2: 15915325252
3: 13456679988
4:
5:
6:
7:
8:
To check the signal strength of the unit, you can send the following SMS command to
the unit.
Text Command:
*CSQ?#
HW: 1.1ver SW: 1.0
ver MW: 1.5ver
7.15 Inquire All Programmed Administrator Number via SMS
7.16 Checking the Signal Strength via SMS
7.14 Inquire the Software and Hardware Version of WT-1010C2 via Voice