User manual

31
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
N stands for Input number 1 – 3
XXXXXX… stands for alert message content
Example:
If you want the alert message to display “Garage Opened!” when input 1 triggered;
you would send the following SMS message to the unit.
*USE1#Garage Opened!
Return Message
USE1=Garage Opened!
The Input Alert Message can be edited and programmed up to 50 characters. You can
change the displayed text by sending the following commands by SMS message to the
unit.
Note: Only support normal abc/ABC English text, no special characters.
Text Command:
*USC[N]#XXXXXX…
N stands for Input number 1 – 3
XXXXXX… stands for alert message content
Example:
If you want the alert message to display “Garage Closed!” when input 1 triggered;
you would send the following SMS message to the unit.
*USC1#Garage Closed!
Return Message
USC1=Garage Closed!
To activate the output relay, you can send a text command via SMS specifying the
number of seconds the output should stay on to the unit. It is possible to set up to
maximum of 99,999 seconds
6.6 Output Settings
6.6.1 Activate Output Relay to Stay On for a Specific Time
6.5 Editing the Inputs Alert Messages (When No Pulse)