User manual

29
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
Programming the WT-1010C2 can also be done via SMS commands using your phone.
Any programming command sent by SMS must be in CAPITAL letters. The fields
between square brackets are parameters; do NOT enter the square brackets. When you
send a command, you will receive the answer for the first time even if your GSM number
is not in the administrator list. This happens because the WT-1010C2 recognizes any
GSM number as administrator and answers to it.
Warning! The administrator number must be programmed into the WT-1010C2 unit first via voice
mode in order to use SMS programming mode.
To set the time, you can send the following SMS command to the unit. The time is
entered in 24 Hour format.
Text Command:
*SETM#HH:MM:SS
HH stands for 2 digits value: Hour
MM stands for 2 digits value: Minute
SS stands for 2 digits value: Seconds
Example:
When *SETM#08:30:15 is applied, the time 08:30:15 will be stored inside the WT-
1010C2 memory.
Return Message
SETM-OK
When PSTN failure, AC failure or Auto Test, the WT-1010C2 will dial the programmable
central station number and transmit the account number along with Contact-ID to the
central station.
Text Command:
*ACCT#XXXX
6. WT-1010C2 Programming Instructions (Via SMS)
6.1 Time Setting
6.2 Setting the Account Number for Event Reporting