User manual

28
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
To acknowledge the above alarms simply press the below command on your phone
and the system will stop calling you.
*123456# (Default password: 123456)
The WT-1010C2 can be programmed to answer all incoming calls automatically even
there is no fixed line phone attached to it. When the call is answered, it allows the owner
to arm or disarm the system by entering a command from their phone’s keypad. To turn
on this function, you can press *35* to proceed.
To turn on this function simply press 1#
To turn off this function simply press 0#
Default Value: 0
Note: Once this function is turned on, the attached fixed line phone will not ring when there is an incoming
call.
Arm and Disarm Command via Voice
Press *123456# to arm the system when WT-1010C2 answered the call
Press *123456* to disarm the system when WT-1010C2 answered the call
Note: 123456 is a 6-digits password that is programmable by *0* function or *PAWO#
command by SMS
AUTO ANSWER
ON&&OFF:
AUTO ANSWER
ON&&OFF: 1
AUTO ANSWER
ON&&OFF: 1 OK
Step 15. Setting the Automatic Call Answering Feature