User manual

13
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
Note: Some telephone sets are sensitive to the GSM radio signal. For this reason you
may hear a characteristic noise in the telephone receiver when calling. If the noise is
disturbing, change the location of the phone set (try to keep it as far as possible from the
WT-1010C2 unit antenna). Usually it is possible to find a suitable location for the phone
with minimal level of interference.
The WT-1010C2 can be programmed manually by a connected normal telephone.
Note: Before commencing programming it is advisable to read the below programming
setting instructions thoroughly. To start with programming, user must plug-in a normal
single line phone to TEL1 (Port 1)
Pick up the handset or press hands free, press **123456# to enter programming mode.
If the password has entered correctly, you should see “HAND FREE…” displayed on WT-
1010C2 screen.
Now you may proceed with programming settings.
When pick up the handset
ENTER
SETTING…
5. WT-1010C2 Configuration Instructions (Via Fixed Line Phone)
5.1 Introduction
Step 1. Enter Programming Mode