User manual

12
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
When power up the WT-1010C2, it will display as below
LOADING :>>>>>
When the terminal is ready to use, it will display as below
Note: Whenever the WT-1010C2 fails to logon to network or fails to detect the SIM card, it will
restart automatically until it has detected the SIM card or successfully logon to network.
After the GSM module is connected to the GSM network, an attached fixed line phone can
be used to make calls. If you pick up the phone, you will hear a dial tone. Simply dial the
number you want to call (as if you are dialing from a normal fixed line phone). You can
also dial the WT-1010C2 unit’s phone number from another phone, and its attached
phone will ring as a normal landline phone would. If there is a busy tone on the attached
telephone set, either the line you are calling is busy, or the GSM communicator is busy
with previous communication at that moment (for example data transfer to the
monitoring station).
WAITING…
WT-1010
4.7 Power u
p
the WT-1010C2
Signal
Power
Battery
4.8 Dialing a number from the attached telephone set