User manual

11
WT-1010C2 USER MANUAL
WT-1010C2 – USER MANUAL – Rev.3.9 – Technical Support: [e-mail]
COPYRIGHT ©2011
WITURA CORPORATION SDN BHD
Inputs & Outputs Wiring Diagram
(View from DB-15 Connector Cable Female Type)
Permanent +V Output Facility
There is a permanent +V output when the WT-1010C2 is power on. This output is
available on the connection PIN8 and ground on the main board. The output voltage is
according to power supply used on WT-1010C2. It can be used to power on other facility
or device.
Note: Installing the SIM Card. Please be sure the initial 4 digit PIN code of SIM card is
disabled. This can be done by placing it in an unlocked Mobile phone and first checking if
the SIM requested any PIN code. If this is the case the PIN code can be disabled using
the security settings on the phone.
Warning! The WT-1010C2 identifies only 3V SIM Card.
Proceed as follows:
1. Slide back the SIM door and lift it up
2. Slide the SIM card into the SIM door making sure that the clipped corner of the SIM
card lines up with the clipped corner of the SIM holder
3. Close the SIM door
4. Slide the SIM door to lock the SIM card in place
4.6 Installin
g
the SIM Card