User`s manual

WT-1018 GSM Fixed Wireless Terminal___________________________________
7
WT-1018 – User Manual – Rev.1.2 – Technical Support: [e-mail] - www.witura.com
COPYRIGHT ©2007 WITURA CORPORATION SDN BHD
Programming Code Setting (Have to enter Password before Start doing the Settings)
Steps:
1. Password Verification
Pick up phone, press
**83211279#. If heard “du~~~” a continuous dialing tone, means the Password
enter correctly, and then will continue to go into programming setting mode. User is able to change the
settings now. If there is no continuous “du~~~”, means the Password enter not correct. And it will not
go into programming setting mode to change the settings. User can hook-on and pick up phone again to
enter the Password.
2. Programming Code
Refer to the Programming Table below. After enter the Programming Code, if you heard a busy tone
follow by the dialing tone, it means wrong programming code. If heard continuous “du~~~”, it means
the successful set up for that programming code. If just heard dialing tone, it means that the settings
area are full or enter wrong programming code.
During the setting for the programming code, user does not need to hook-on the Phone. When user
heard dialing tone after ONE setting means the user can continue the following setting.
3. To Quit from the Programming Code Setting
In Hook-on mode or Press “hand free” to quit from the setting.
No. Definition Program Code Description
1 Enter Password. Go
into Programming
Setting
**XXXXXXXX# After Password Verification, will enter
to the Programming Setting Mode.
(Initial Password for factory leaving is
sets up as “83211279”
2 Setting IP or
Gateway Number
*2*XXXXXXXXXXXX#
After doing this setting, when making
calls, it will automatically dial Gateway
Number in front of the Destination
Number.
*2*#
Delete the IP or Gateway Number
setting. All the calls are made will not
adding Gateway Number in front of the
Destination Number.
3 Restrict Incoming
Calls
*3*1*#
Barred all Incoming Calls
*3*1*0#
Cancel the setting for Barred Incoming
Calls
4 Restrict Local Calls
*3*2*#
Barred all Local Calls
*3*2*0#
Cancel the setting for Barred Local Calls
Restrict
International Calls
*3*3*#
Barred all International Calls
*3*3*0#
Cancel the setting for Barred
International Calls
5 Restrict National
Calls
*3*4*#
Barred all National Calls