User`s manual

WT-1018 GSM Fixed Wireless Terminal___________________________________
6
WT-1018 – User Manual – Rev.1.2 – Technical Support: [e-mail] - www.witura.com
COPYRIGHT ©2007 WITURA CORPORATION SDN BHD
The installation for connecting to register cost equipment
If users demand register cost during calls, register cost equipment can be connected between terminal and
ordinary telephone. Register cost equipment registers cost according to anti-polarity signal that is provided
by terminal.
Turn on and Turn off Wireless Terminal
Turn on: Connect the input end of power adapter to power socket and the output end to the port of
“DC6.5V” turn on terminal. About 15 – 45 seconds later (subject to local wireless network), the
terminal will logon successfully.
Turn off: Turn the switch to the OFF side and disconnect power adapter to turn off the terminal
Making Calls
1. Lift the handset or press “hand-free” key, you will hear dialing tone, then you can dial the telephone
numbers you want to call.
2. Dialing: dial the telephone numbers you want to call
3. On completion of dialed digits, you can press “#” to transmit telephone numbers. If you don't dial any
key for continual 6 seconds during the dialing, the terminal transmits the dialed telephone numbers
automatically.
4. If there is PSTN line input, the dialing numbers will automatically go through PSTN line. If the user
wants the dialed number to go through GSM then the user must press “*” before the destination
numbers.
5. If the user dial an International number start from “0” the dialing numbers will automatically go
through GSM.
6. When it is necessary to register cost, the terminal sends out anti-polarity signal (the signal is used to
register cost by register cost equipment). During a call, dial digital key or “*” or “#” to output DTMF.
7. If the calling party or called party hangs up, the terminal stops sending out anti-polarity signal.
8. If users dial barred numbers, telephone will give out the sound of three-time toot to ask the user to hang
up.
Answering Incoming Calls
When some calls are coming in, the telephone rings and the terminal will displays the incoming telephone
numbers on the screen. Now users can lift the handset or press “hand-free” to answer the call.