User`s manual

WT-1018 GSM Fixed Wireless Terminal___________________________________

WT-1018 – User Manual – Rev.1.2 – Technical Support: technical@witura.com - www.witura.com

Installing the SIM Card

Proceed as follows:

1. Slide back the SIM door and lift it up

2. Slide the SIM card into the SIM door making sure that the clipped corner of the SIM card lines up with

the clipped corner of the SIM holder

3. Close the SIM door

4. Slide the SIM door to lock the SIM card in place

Setting up the Terminal

Installation Condition

Require 220v AC power. GSM signal can cover the area where the terminal is placed. Signal quality affects

voice quality direct.

The installation for connecting to ordinary telephone direct

1. Install the SIM card proceeding as “Installing the SIM Card” on page 3.

2. Connect one end of the telephone line to “Telephone port” and the other ends connect to a telephone.

3. Connect PSTN Line to “Line Port”.

4. Install the antenna and power supply well. The distance between telephone and terminal is 1.5m at

least.

5. Connect one end of the power adapter to “Power port” and another end connects to 220v AC power.

About 10-45 seconds later, the terminal works in gear (The login time is different according to local

network).

When the terminal is ready to use, it will display as below

WT-1018

Draw your attentions: Because there are many types of ordinary telephone and their electric parameters

are different .In order to avoid mutual disturbance between telephone and terminal and affects voice quality

.The distance between telephone and terminal must be beyond 2m.

Signal

Power