User manual

WT-248 GSM 8 Ports Analog Gateway

WT-248 – USER MANUAL – Rev.1.5 – Technical Support: technical@witura.com

1. The whole pack of the PRI Gateway includes:

• Analog Channel Bank (Main Unit) 1 set

• High Gain Antenna 2 pcs

• Antenna Splitter 2 pcs

• 110 – 220V AC Power Line 1 pcs

• Telephone Cord 8 pcs

2. Installation Procedure

The equipment provides digital GSM network communication, which required a

valid SIM Card.

a) Put the GSM Analog Channel Bank in pedestal

b) Switch of the power on the behind-panel (switch is kept at “O”)

c) Insert the valid SIM Card

• Screw off the two fixed screws in the bottom front-panel, and remove the

bottom front-panel

• Insert the SIM Card in the correct direction (the most right hand route is

from left to the right, others are from right to left)

• Fix the bottom cover, and tighten the screws

d) Wiring antenna into antenna electric outlet

e) Connect one end of the line with the RJ-11 telephone outlet, and the other end

with the telephone (fee counter)

f) Connect one end of a 85-240V AC power adapter into 110-220V power outlet,

the other end into 220V power outlet on behind-panel

g) Open the power switch on behind-panel (switch is placed in “-” appearance)

After the equipments installed, each route of the equipments has to be initially

systematic configured by dealer or network service provider to assure the formal

operation of equipments.

Configuration And Installation