User manual
52
GSM VOIP Gateway Series
GSM VOIP Gateway USER MANUAL – Rev1 – Technical Support: technical@witura.com
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
The authentication mode is classified into the password authentication, trust list
authentication, and password or trust list authentication.
Downlink (VoIP to PSTN) Uplink (PSTN to VoIP)
authentication mode authentication mode
The setting is as follows: Select “Forward to PSTN Authentication Mode” >
“Password Authentication”. Enter the password in “Call PSTN Authentication
Password”.
As indicated in the above figure, for call s from the VoIP to the PSTN, when the
second dialing tone is heard, dial the set password and the call will be connected.
For call s from the PSTN to the VoIP), when “Please Enter the Password” is played,
enter the password and then the call will be connected.
3.7.2 Authentication Mode Setting
3.7.2.1 Password Authentication
3.7.2.2 Trust List Authentication
25
GSM VOIP Gateway Series
GSM VOIP Gateway
USER MANUAL –
Rev1
–
Technical Support: technical@witura.com
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
Set these parameters according to the network the user uses.
C. PPPOE
PPPoE (Point-to-point protocol over Ethernet) is a network protocol that
compresses the PPP in the Ethernet. Select PPPoE dialing, and enter the account
and password provided by the network provider.
D. 802.1qVLAN
When the network serving the user provides the VLAN service, enter the
parameter as required.
E. Advance…
Click Advance, and the Hardware address and Broadcast address are displayed in
the page.
The hardware address is used to enter the MAC address in the format of XX: XX:
XX: XX: XX: XX.
The broadcast address is used to communicate with other computers connected
to the GSM VOIP Gateway.
The PC port can be set to connect other network equipment through the route or
bridging mode. The two setting modes are as follows:
A. Bridging
When the PC port is set to the bridging mode, the relation between the LAN port
and the PC port is layer 2 switching. The network equipment connected with the
PC port same as the connection with the LAN port.
3.4.2
PC Port Setting