User manual

20
GSM VOIP Gateway Series
GSM VOIP Gateway USER MANUAL – Rev1 – Technical Support: [e-mail]
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
The SMS server sends the request to the mobile phone via the GSM VOIP
Gateway, or the mobile phone sends the request to the SMS Server via GSM VOIP
Gateway.
SMS server address: This is for filling the IP of the SMS server. Please make
sure that server is installed with the GSM VOIP Gateway SMS management server
software independently developed by Witura Corporation Sdn Bhd (The software
can be obtained from our technical personnel).
SMS server port: It is the SMS port of the SMS server. The default value is
44444. It must be consistent with that of the server if modified on the server.
Authentication ID: It is the user ID. Make sure that the server has
corresponding ID.
Authentication password: It is for filling the user password.
Note: The SMS send cli ent of the WT-2204 and WT-2208 are in the call set
options, which needs the support of the GSM VOIP Gateway SMS management
server.
The GSM VOIP Gateway support the GSM/GPRS 900/1800 and 850/1900 bands.
3.3.9 GSM Band
57
GSM VOIP Gateway Series
GSM VOIP Gateway USER MANUAL – Rev1 – Technical Support: [e-mail]
COPYRIGHT ©2011 WITURA CORPORATION SDN BHD
C: Mode 3
In this mode, the GSM VOIP Gateway sets the SIP number of the GSM VOIP
Gateway as the calling number of the call and the called number as the short
message content and the number of the short message sender, whose format is
short message content*the number of the short message sender.
D: SMS Dial Prefix
When the GSM VOIP Gateway initiates the SMS call, the GSM VOIP Gateway will
change the prefix number to the called number prefix.
Examples of SMS Dialing:
In the following SMS dialing examples, the account of the SIP of the GSM VOIP
Gateway is set as follows:
Mode 1:
When a short message of “8675588228822” is sent from the mobile phone
number ([phone] to the GSM VOIP Gateway, the GSM VOIP Gateway
will send the following call request signaling: