User manual

1018

USER MANUAL

WT-1018C1 – USER MANUAL – Rev 1.5 – Technical Support: Technical@witura.com

WITURA CORPORATION SDN BHD

4. Install the antenna and power supply well. The distance between telephone and

terminal is 1.5m at least.

5. Connect one end of the power adapter to “Power port” and another end

connects to 220v AC power.

6. Turn on the terminal.

7. When the terminal is ready to use, it will display as below

WT-1018

Draw your attentions: Because there are many types of ordinary telephone and their

electric parameters are different. In order to avoid mutual disturbance between

telephone and terminal and affects voice quality. The distance between telephone and

terminal must be beyond 2m.

Setup the function of locking SIM card and locking terminal

To enable this function, the PIN code of both SIM card and the terminal must be

setup and enabled. To setup and enable the PIN code of the SIM card, it can

be done by using the security settings on any mobile phone or on WT-1018C1

terminal. To setup the PIN code for the terminal, you can first turn on the

terminal without installing the SIM card. When turned on, it will display as

below

LOADING:>>>

Insert SIM

Now you can lift the handset or press the “hand-free” key of the connected

phone.

Input the password to enter programming mode by pressing **12345678#

. If

password entered correctly, it will display as below.

Signal

Power