User manual

5
WT
-
1018
C1
USER MANUAL
WT-1018C1 – USER MANUAL – Rev 1.5 – Technical Support: [e-mail]
COPYRIGHT ©2009 WITURA CORPORATION SDN BHD
 Don’t knock terminal to avoid breaking the case.
 Don’t use chemic impregnant to clean terminal, but use dry soft cloth to make it
clean.
Proceed as follows:
1. Slide back the SIM door and lift it up
2. Slide the SIM card into the SIM door making sure that the clipped corner of the
SIM card lines up with the clipped corner of the SIM holder
3. Close the SIM door
4. Slide the SIM door to lock the SIM card in place
Note: To use the terminal without any locking SIM or locking terminal, please be sure
the initial 4 digit PIN code of SIM card is disabled. This can be done by placing it in an
unlocked Mobile phone and first checking if the SIM requested any PIN code. If this is
the case the PIN code can be disabled using the security settings on the phone. To
enable the function of lock SIM and lock terminal on the terminal, the PIN code of SIM
card and the terminal must be set and enabled.
Installation Condition
Require 220v AC power. GSM signal can cover the area where the terminal is
placed. Signal quality affects voice quality direct.
The installation for connecting to ordinary telephone direct
1. Install the SIM card proceeding as “Installing the SIM Card” on the above.
2. Connect one end of the telephone line to “Telephone port” and the other ends
connect to a telephone.
3. Connect PSTN Line to “Line Port”.
4. Installing the SIM Card
5. Setting up the Terminal