User manual

13
WT
-
1018
C1
USER MANUAL
WT-1018C1 – USER MANUAL – Rev 1.5 – Technical Support: [e-mail]
COPYRIGHT ©2009 WITURA CORPORATION SDN BHD
Steps:
A. Enter Programming Mode
Pick up the handset or press “hand-free” on the connected telephone, input
**12345678#. If heard “du~” a short dialing tone, means the Password has
entered correctly, and then it will continue to programming setting mode. User
is able to do programming at this state. If there is no tone and error appears on
the screen, means the Password entered is not correct. And it will not go into
programming setting mode. User can hook-on and pick up phone again to enter
the Password.
B. Getting Started with Programming Code
After enter the Programming Code, if there is no tone and error appears on the
screen, it means wrong programming code. If heard “du~” a short dialing tone,
it means the successful set up for that programming code.
During the setting for the programming code, you do not need to hook-on the
Phone. After ONE successful setting, you can proceed with the next
programming setting.
C. To Quit from the Programming Mode
Hook-on the phone or press “hand free” to quit from the setting.
Pick up the handset or press hands free, press **12345678# to enter programming
mode. If the password has entered correctly, you should see “HAND FREE…”
displayed on WT-1018C1 screen.
Now you may proceed with programming settings.
When pick up the handset
DIAL
9.2 Programming Setting Instructions
Step 1: Enter Programming Mode