User manual

12
WT
-
1018
C1
USER MANUAL
WT-1018C1 – USER MANUAL – Rev 1.5 – Technical Support: [e-mail]
COPYRIGHT ©2009 WITURA CORPORATION SDN BHD
(the signal is used to register cost by register cost equipment). During a call,
dial digital key or “*” or “#” to output DTMF.
7. If the calling party or called party hangs up, the terminal stops sending out
anti-polarity signal.
8. If users dial barred numbers, telephone will give out the sound of three-time
toot to ask the user to hang up.
When some calls are coming in, the telephone rings and the terminal will displays the
incoming telephone numbers on the screen. Now users can lift the handset or press
“hand-free” to answer the call.
The WT-1018C1 can be programmed manually by a connected ordinary telephone.
Note: Before commencing programming it is advisable to read the below programming
setting instructions thoroughly.
8.2 Answering Incoming Calls
9. Programming Instructions
9.1 Introduction
Connect to TEL1