User manual
11
WT
-
1018
C1
USER MANUAL
WT-1018C1 – USER MANUAL – Rev 1.5 – Technical Support: Technical@witura.com
COPYRIGHT ©2009
WITURA CORPORATION SDN BHD
You will have to check with the network operator for PUK to unlock the SIM card.
If users demand register cost during calls, register cost equipment can be connected
between terminal and ordinary telephone. Register cost equipment registers cost
according to anti-polarity signal that is provided by terminal.
Turn on: Connect the input end of power adapter to power socket and the output end
to the port of “DC12V” turn on terminal. About 15 – 45 seconds later
(subject to local wireless network), the terminal will logon successfully.
Turn off: Turn the switch to the OFF side and disconnect power adapter to turn off
the terminal
1. Lift the handset or press “hand-free” key, you will hear dialing tone, then you
can dial the telephone numbers you want to call.
2. Dialing: dial the telephone numbers you want to call
3. On completion of dialed digits, you can press “#” to transmit telephone
numbers. If you don't dial any key for continual 6 seconds during the dialing,
the terminal transmits the dialed telephone numbers automatically.
4. If there is PSTN line input, the dialing numbers will automatically go through
PSTN line. If the user wants the dialed number to go through GSM then the
user must press “*” before the destination numbers.
5. If the user dial a number start with “1”, “2”, “3”, “4”, “5”, “6”, “7”, “8”, “9” the
dialing numbers will automatically go through PSTN. When user dial a National
or International Call number start with “0” and “00”, the dialing numbers will
automatically go through GSM. IP or Gateway Number will be added in front of
destination number automatically when dialing International Call “00”. If there
is no IP or Gateway Number, it will go through GSM as normal.
6. When it is necessary to register cost, the terminal sends out anti-polarity signal
6. The Installation for connecting to register cost equipment
7. Turn on and Turn off Wireless Terminal
8.1 Making Calls
8. Making Calls and Answering Incoming Calls