User manual

Version: 10/09 Page 5

Chimney

The Klassic must be installed using a Class A UL 103 HT approved factory-built chimney system or a

code-approved masonry chimney with a flue liner. In Canada, the installation must conform to NFPA 211

or CAN/CSA-B365. The chimney must extend through the roof at least 3’ (1 m), and 2’ (6 m) above any

structure within 10’ (3 m). The condition of the chimney and height is very important. We recommend a

minimum height of 10’ (3 m) above the stove collar. However, additional chimney height may be required

to maintain adequate draft - consult you dealer.

Note! Mount the special collar using the included hardware. When installing the first piece of pipe (at the

stove), place the pipe inside the collar, that is designed so any moisture or creosote will drip back into the

stove and burn away. Install the remaining stovepipe segments with the crimped end down whenever

possible.

Required Installation Components

A. Chimney cap

B. Insulated chimney

C. Storm collar

D. Roof flashing

E. Ceiling support box or joist shield / firestop

spacer

F. Chimney connector pipe

Chimney connector

Aluminum and galvanized steel pipe is not

acceptable for use with the wood stoves. These

materials cannot withstand the extreme

temperatures of a wood fire and can give off

toxic fumes when heated. Do not use connector

pipe to go through a wall or ceiling.

Each chimney connector or chimney connector

section must be installed to the stove flue collar

and to each other with the male (crimped) end

toward the stove.