User manual

Set up and Installation

To minimize the weight of the insert before installation, it is

possible and simple to dismount the door by lifting it up and pulling

it out of the lower hinge. The wood holder in the combustion chamber

should not be removed.

Illustration I:

Place the insert into the

opening. Adjust it by using the

3 screws at the bottom.

Version: 10/09 Page 5

The insert must be adjusted both

horizontally and vertically.

Also adjust the door at the

hinges and the fittings.

Before replacing the baffle

plate and the vermiculite

panels, place the stove collar

in the smoke outlet hole, and

put the gasket at the bottom.

After this, bend the four small

tabs to affix the collar.

Illustration II:

Door

adjustments

Botto

adjustments

First, put in the rear panel.

After, replace the baffle plate.

Please note that this plate must

rest on the attached holders.

Place the gasket on the back of the

baffle plate.

Place the direct air device.

Then place the side panels and

finally the bottom panels.

The insert MUST meet the required

minimum distance to combustible

materials.

Rear panel Bottom panelSide panel

Baffle

plate

Baffle

plate

holder

Gasket

Stove collar