User manual

Specifications

UL 1777 Listed chimney liner (with a 6” (15cm) diameter) up

through the block off plate of an existing masonry chimney, a

zero-clearance chimney, or Class A, UL-103 HT, 6” (15cm)

diameter chimney

Dimensions (h x w x d) – 21 ” x 28 ” x 18 ” (53cm x 70cm x 45cm)

Firebox Dimensions (h x w x d) – 14” x 24 ” x 12 ” (35cm x 60cm x 30cm)

Thermal Output – 20,000 BTU (6 kW); range is 11,100-28,800 BTU

Approximate heating area – 600-1,500ft

Minimum stove pressure at above output – 15 Pascals

Efficiency – 75%

Tested EPA emission particulate rate – 6.6 grams/hour

Minimum distances from edge of Insert Face Plate to combustible

material – as shown:

A = Distance to furniture – 36 ”(91cm)

B = Front protection – 20 ”( 51cm) to unprotected combustible

5.5 ”(39cm)

G = ” protruding combustible top trim –

H = Minimum distance to combustible material (front facing) –

I = Distance to the floor – 6.5 ” (16.5cm)

floor

C = Side floor protection – 8 ”(20cm) from fuel-loading door

D = Distance to a combustible adjacent sidewall – 1

E = Distance to ¾ ”p rotruding side trim – 2” ( 5cm)

F = Distance to a combustible mantel – 26 ”( 66cm)

Distance to ¾

19.5 ”(50cm)

19 ”(48cm)from top of the unit

Note:

solid cement or block (not brick or tile over combustible material).

A heat shield or protective wall may be used to reduce clearances if

approved by the regulatory authority. Clearances to noncombustible

materials are 2” (5cm), but note that “noncombustible ” must be

Version: 10/09 Page 4