Installation and Operating Instructions

Installation
6.3 Installation instructions flinkey CAN
WARNING
Risk of injury!
Without sufficient fixing the flinkey CAN can cause hazards for the
vehicle driver or passengers in case of a full brake application (i.e.
head injuries). Make sure that the CAN Box does not cause any risks
to the drivers or passengers. Always make sure the flinkey CAN is
positioned safely in the vehicle.
Since the flinkey CAN is connected to the partner device by cable and, depending on the
type of vehicle, it is necessary to remove the vehicle key, the possible installation positions
are limited. The following installation positions are recommended:
- in the glove compartment
- under the drivers’ seat
- under the passengers seat
- In the boot
WARNING
Risk of burn!
Always protect the flinkey CAN from direct sunlight and never place
the flinkey CAN in direct sun light.
To avoid overheating, do not cover the device, do not use near heat
sources or in direct sunlight and only at ambient temperatures of
between -40°C and +85°C.
WARNING
Risk of frostbite!
If the box was stored in the temperature range from -40..0°C for a
long time there is a risk of frostbite! Only handle the box with suitable
gloves!
The flinkey CAN Box can be affixed in the car with the hook-and-loop fasteners, to protect
the box from moving when the car is being driven. The steps below describe how to affix
both the loop and hook strips. Optionally, you can also use the vehicle floor as loops. In that
case, remove the loop strip.
NOTICE
Make sure to place the hook-and-loop strips at room temperature. Make sure that
the surface is clean and dry.
To affix the flinkey CAN:
1. Clean the surface of the flinkey CAN Box with a soft, clean, lint-free cloth dampened
with a mild detergent solution or water.