Data Sheet

MANUAL flinkey CAN Box
20220609 2/3
Function
Without a partner device, the flinkey CAN Box has no function; without a
connected partner device, both the logic and the power supply are missing.
The corresponding commands must be defined with the respective partner and
integrated into the firmware of the flinkey CAN Box.
The commands are sent via a well-defined wired communication (CAN
communication using four wires - plus and minus line, as well as two
communication lines).
The key bed for the vehicle key is equipped with white and red LEDs, which can
be used for status indication.
Partner device
With the help of the flinkey CAN Box, it is possible to expand an existing
partner device to include the functionality of locking and unlocking a vehicle.
These partner devices are usually so-called TCUs (Telemetry Control Units),
which map the entire logic (user administration; authorisations). The partner
device therefore decides what the flinkey CAN Box has to do and when, by
sending the partner device the corresponding command.
Installation manual
Since the flinkey CAN Box is connected to the partner device by cable and,
depending on the type of vehicle, it is necessary to remove the vehicle key, the
possible installation positions are limited.
As a rule, a fixed position of the flinkey CAN Box in the glove compartment,
under the driver's or passenger's seat, or in the boot makes sense.
The installation of the partner device and flinkey CAN Box should be reserved
exclusively for trained personnel.
 Installation manual