Specification Sheet
Table Of Contents
- Tutorial Link
- Contact
- Application
- Contents
- 2 Features
- 3 Specification
- 5 Casing Specification
- 6 Communication Protocol
- 6.1 Output Data Format
- 6.2 Config Commands
- 6.2.1 Register Address
- 6.2.2 Save Configuration
- 6.2.3 Calibrate
- 6.2.4 Installation Direction
- 6.2.5 Sleep/ Wake up
- 6.2.6 Algorithm Transition
- 6.2.7 Gyroscope Automatic Calibration
- 6.2.8 Return Content
- 6.2.9 Return Rate
- 6.2.10 Baud Rate
- 6.2.11 Set X Axis Acceleration Bias
- 6.2.12 Set Y Axis Acceleration Bias
- 6.2.13 Set Z Axis Acceleration Bias
- 6. 2.14 Set X Axis Angular Velocity Bias
- 6.2.15 Set Y Axis Angular Velocity Bias
- 5.2.16 Set Z Axis Angular Velocity Bias
- 6.2.17 Set X Axis Magnetic Bias
- 6.2.18 Set Y Axis Magnetic Bias
- 6.2.19 Set Z Axis Magnetic Bias
WT901SDCL | Datasheet v20-0605 | http://wiki.wit-motion.com/english
- 23 -
6. 2.14 Set X Axis Angular Velocity Bias
0xFF
0xAA
0x08
GXOFFSETL
GXOFFSETH
GXOFFSETL：Set X axis Angular velocity bias low byte
GXOFFSETH：Set Y axis Angular velocity bias high byte
GXOFFSET= (GXOFFSETH <<8) | GXOFFSETL
Note：After setting the angular velocity zero deviation, the output value of
the angular velocity is the sensor measurement value minus the zero
deviation value.
6.2.15 Set Y Axis Angular Velocity Bias
0xFF
0xAA
0x09
GYOFFSETL
GYOFFSETH
GYOFFSETL：Set X axis Angular velocity bias low byte
GYOFFSETH：Set X axis Angular velocity bias high byte
GYOFFSET= (GYOFFSETH <<8) | GYOFFSETL
Note：After setting the angular velocity zero deviation, the output value of
the angular velocity is the sensor measurement value minus the zero
deviation value.
5.2.16 Set Z Axis Angular Velocity Bias
0xFF
0xAA
0x0a
GXOFFSETL
GXOFFSETH
GZOFFSETL：Set Z axis Angular velocity bias low byte
GZOFFSETH：Set Z axis Angular velocity bias low byte
GZOFFSET= (GZOFFSETH <<8) | GZOFFSETL
Note：After setting the angular velocity zero deviation, the output value of
the angular velocity is the sensor measurement value minus the zero
deviation value.