Installation Manual

6
alternating sequence for 5 seconds (LED1-LED2-LED1-LED2) this
indicates that pairing has failed and the unit will then return to
normal operation mode with just LED 1 illuminated.
9. If the WiTi Wireless Brake Controller did not detect a PAIRING
partner during the pairing sequence, the LED display will display
a message reading, “Pairing Timeout” followed by a message
“Pairing Failed”. Repeat the pairing.
Brake Controller Calibration
The WiTi Wireless Brake Controller integrates with the WiTi Anti-
The Unit installed in the caravan or trailer. The WiTi Anti-The Unit
should be installed vertically and facing either to the front or the
rear of the caravan or trailer. The WiTi Break Controller uses input
from the accelerometer located in the trailer unit and uses gravity as
a reference point for calibration. The WiTi Trailer Unit is calibrated
at factory however, in the event it requires re-calibration or the
installation or caravan / trailer is not level when hitched, please follow
the following steps:
1. WiTi must be paired and linked status on the LCD Screen must be
lit indicating a paired state
2. The Caravan / Trailer must be stationery (any movement will
prevent the calibration)
3. The Caravan / Trailer must be on a level surface (if not level a
faulty calibration will result)
4. Press the brake pedal and keep it depressed during the
calibration sequence
5. Turn the brake controller dial clockwise to the maximum setting
(100%)
6. Press the brake controller dial button
7. Once successfully calibrated the clearance lights on the caravan
will ash 6 times rapidly. The WiTi Brake Controller is now
recalibrated and the dial can be returned to it’s previous setting.