Wireless Electric Brake Controller Operation & Installation Guide Australia’s Most Advanced Electric Brake Controller 1
Warnings & Safety Instructions Do not operate the WiTi Brake Controller unless you have read and understood this manual and WiTi is installed as per the instructions. Contents 1. WiTi Wireless Electric Brake Controller 2. WiTi Wireless Communication Module 3.
Operation and Installation Instruction The WiTi Wireless Electric Brake Controller plugs into a standard 12V cigarette lighter socket and includes an LCD screen and a dial for gain adjustment and manual override. The WiTi Wireless Electric Brake Controller is supplied with a separate WiTi Communication Module that must be connected to an existing Anti-Theft Unit in the caravan or trailer. Locate the Communication Module next to the Anti-Theft Unit and connect with the supplied RJ45 cable.
electric brakes on the caravan or trailer is measured and smoothed electronically to provide a more comfortable and safer towing experience and eliminate harsh jolting. To adjust braking sensitivity the dial can be turned to the left to reduce trailer braking or to the right to increase trailer braking, the LCD screen will display the new setting as a percentage gain that will be applied.
2. 3. 4. 5. 6. range of the WiTi Wireless Brake Controller. On the WiTi Communication Module press and hold the “PAIR” Button While the “PAIR” Button is still depressed, press the RESET Button for half a second and then let go of the RESET button When the RESET buttonbutton is released, you willyou notice 4. When the RESET is released, will LED2 notice flashingLED2 rapidly while rapidly LED 1 is still LED solid.1 Let flashing while is go of the PAIR button. The WiTi Trailer Unit is now in still solid.
alternating sequence for 5 seconds (LED1-LED2-LED1-LED2) this indicates that pairing has failed and the unit will then return to normal operation mode with just LED 1 illuminated. 9. If the WiTi Wireless Brake Controller did not detect a PAIRING partner during the pairing sequence, the LED display will display a message reading, “Pairing Timeout” followed by a message “Pairing Failed”. Repeat the pairing.
Limited Warranty If Leisure Technologies determines that you are covered by a warranty as set in the Australian consumer law the company shall at its expense: (a) repair the product, or replace the product with a new unit (which may have used refurbished parts of similar quality); (b) ship the repaired or replaced unit back to you; (c) warrant the repaired or replaced product for a reasonable period; and/or (d) refund money paid for the product. The Company has the discretion as to which remedy applies.
• Installation of WiTi products may require consumers to have knowledge and experience using powered tools and electrical wiring. Consumers without such knowledge are to refrain from attempting any installation of WiTi products and to consult their nearest WiTi specialist or qualified Auto Electrician. • Prior to the installation of any WiTi product consumers are taken to have comprehensively read and understood the appropriate WiTi operation and installation guide included with the product.
