Installation Manual

5
WiTi Wireless Towing Interface and Communication Module
Indicator Lights
There are two LEDs embedded in the WiTi Logo on
the Wireless Towing Interface and Communication
Module.
When the unit is powered LED 1 (Red) will
illuminate. When the unit is paired and linked then
LED 2 (orange) will illuminate.
Pairing a new WiTi Wireless Towing Interface and
Communication Module
Ensure the WiTi Wireless Towing Interface and
WiTi Communication Module are plugged in and
powered on (LED 1 is lit) and in range of each other
- within 10 meters.
On the WiTi Wireless Towing Interface unit press
and hold the “PAIR” Button.
Whilst still depressing the “PAIR” button, press the RESET Button for half a second
and then let go of the RESET button.
When the RESET button is released, you will notice LED2 ashing rapidly while
LED 1 is still solid. Let go of the PAIR button. The WiTi Wireless Towing Interface
is now in PAIRING mode. The unit will stay in pairing mode for ve minutes while
searching for the Wireless Communication Module.
Repeat the Pairing Process on the Communication Module in the Caravan or
Trailer.
On successful pairing the WiTi LEDs will ash simultaneously for 5 seconds on
both units to indicate that they have successfully paired with each other. Once
the LED’s stop ashing both units will exit PAIRING Mode and return to normal
operation. Both LED1 and LED2 will now be illuminated when they are in range and
powered.
If either unit did not detect a PAIRING partner during the pairing sequence, then
LED 1 and LED 2 will ash in an alternating sequence for 5 seconds (LED1-LED2-
LED1- LED2) this indicates that pairing has failed and the unit will then return to
normal operation mode with just LED 1 illuminated. Repeat the pairing process.