Installation Manual
2
Warnings & Safety Instructions
Do not operate WiTi unless you have read and understood this manual and
WiTi is installed as per the instructions.
• WiTi Wireless Towing Interface requires WiTi Anti-The to be installed in the
caravan or trailer.
• WiTi automatically pairs when in range but it is always good practice to check
the lights before towing to ensure they are all operating.
WiTi Wireless Towing Interface
WiTi replaces the cables connecting a tow vehicle and trailer or caravan with
an advanced Wireless Towing Interface. WiTi transmits all lighting and braking
signals from the tow vehicle to the caravan or trailer wirelessly. WiTi complies with
Australian Design Rules when installed as directed.
WiTi Wireless Towing Interface supports CanBus vehicles and vehicles with
advanced electronics. WiTi supports vehicle specic towing modes and features
for example, disabling reverse sensors when hitched. These features will be
enabled when the WiTi Wireless Towing Interface is in range and paired with the
WiTi Anti The unit in the caravan or trailer. Please refer to your vehicle hand book
for vehicle specic towing modes.
WiTi supports all third party electric brake controllers as well as the WiTi Wireless
Electric Brake Controller (sold separately).
Note: Transmission of lighting signals is disabled when the alarm is activated
on the trailer.
Specications
Nominal System Voltage 12V
Operating Voltage 9V - 15V
Operating Current 38mA
Standby Current - low power mode 2mA
Operating Temperature -20C - 60C
FCC ID 2AC7Z-ESP32
Weight 120g