Owner's Manual
Table Of Contents
- Installation and operating instructions
- Minimum requirements
- Sleep/Sleep Analyzer description
- Setting up my Sleep/Sleep Analyzer
- Using my Sleep/Sleep Analyzer
- Tracking my sleep apnea (Sleep Analyzer - EU users)
- Linking my Sleep/Sleep Analyzer to IFTTT
- Managing my data
- Adding a Wi-Fi network
- Dissociating my Sleep/Sleep Analyzer
- Performing a factory reset of your Sleep/Sleep Analyzer
- Cleaning and maintenance
- Technology description
- Specifications
- Document release overview
- Warranty
- Regulatory statements
- Quick Installation Guide
EN-43
Sleep/Sleep Analyzer
v5.0 | April 2020
5. Remove the air from the sensor. Please refer to the picture below.
6. Unplug Sleep/Sleep Analyzer.
7. Put the inner part of the device back into the textile cover.
Make sure to flatten the sensor all over its surface in the textile cover.
Updating the firmware of my Sleep/Sleep Analyzer
To update the firmware of your Sleep/Sleep Analyzer, perform the following
steps:
1. Open the Health Mate app.
2. Go to Devices > Sleep/Sleep Analyzer.
3. Tap Check for updates.