Owner's Manual
Table Of Contents
- Installation and operating instructions
- Minimum requirements
- Sleep/Sleep Analyzer description
- Setting up my Sleep/Sleep Analyzer
- Using my Sleep/Sleep Analyzer
- Tracking my sleep apnea (Sleep Analyzer - EU users)
- Linking my Sleep/Sleep Analyzer to IFTTT
- Managing my data
- Adding a Wi-Fi network
- Dissociating my Sleep/Sleep Analyzer
- Performing a factory reset of your Sleep/Sleep Analyzer
- Cleaning and maintenance
- Technology description
- Specifications
- Document release overview
- Warranty
- Regulatory statements
- Quick Installation Guide
EN-42
Sleep/Sleep Analyzer
v5.0 | April 2020
Cleaning and maintenance
Cleaning my Sleep/Sleep Analyzer
To clean the textile cover of the Sleep/Sleep Analyzer, gently remove the cover
first. Note that the cover can be machine washed, but do not tumble dry or iron
it. We recommend you to wait until the cover is completely dry before replacing it
on Sleep/Sleep Analyzer.
Do not, under any circumstance, use any solvent to clean your
Sleep/Sleep Analyzer.
Deflating my Sleep/Sleep Analyzer
To defalte your Sleep/Sleep Analyzer, perform the following steps:
1. Make sure to place the inner part of the Sleep/Sleep Analyzer out of its textile
cover.
2. Put the lower part towards you.
A notch with the word Reset below indicates the location of the reset button.
3. Unplug, then plug Sleep/Sleep Analyzer using the provided adapter.
4. Press the reset button successively three times.
A slight click indicates that the Sleep/Sleep Analyzer valve is open. The sensor
should slightly deflate.
Important: Keep the sensor plugged during the whole process. When the
sensor is unplugged, the valve closes and prevents any air input/output of the
Sleep/Sleep Analyzer. Note that the valve closes after 3 minutes.