Owner's Manual
Table Of Contents
- Installation and operating instructions
- Minimum requirements
- Sleep/Sleep Analyzer description
- Setting up my Sleep/Sleep Analyzer
- Using my Sleep/Sleep Analyzer
- Tracking my sleep apnea (Sleep Analyzer - EU users)
- Linking my Sleep/Sleep Analyzer to IFTTT
- Managing my data
- Adding a Wi-Fi network
- Dissociating my Sleep/Sleep Analyzer
- Performing a factory reset of your Sleep/Sleep Analyzer
- Cleaning and maintenance
- Technology description
- Specifications
- Document release overview
- Warranty
- Regulatory statements
- Quick Installation Guide
EN-41
Sleep/Sleep Analyzer
v5.0 | April 2020
Performing a factory reset of your
Sleep/Sleep Analyzer
All data that wasn't synced before resetting your Sleep/Sleep Analyzer will be
lost permanently.
Factory resetting your Sleep/Sleep Analyzer allows you to delete all of the data
stored on it. Factory resetting completes the dissociation process.
Factory resetting your Sleep/Sleep Analyzer will not remove any of the data
that was synced from the Health Mate app.
To reset your Sleep/Sleep Analyzer, perform the following steps:
1. Go to theSettingsof your mobile device, selectBluetoothand locate
Sleep/Sleep Analyzer in the list of devices. Select the small icon to the right of
the sleep sensor and select the option toForgetorRemovethe device.
2. Make sure to place the inner part of the Sleep/Sleep Analyzer out of its textile
cover.
3. Put the lower part of the device towards you.
A notch with the word Reset below indicates the location of the reset button.
4. Unplug, then plug Sleep/Sleep Analyzer using the provided adapter.
5. Press and hold the Reset button for five seconds.
The LED on the back of the device will flash red three times, then flash green
continuously one time.
A flashing blue LED indicates that the reset procedure has been done
successfully.
6. Put the inner part back into the textile cover.
Make sure to flatten the sensor all over its surface in the textile cover.