User's Manual

Table Of Contents

MTK952 User Manual

rev.06

QUICK START INSTRUCTION

1. Connect to the power outlet using the supplied power cable (see rear panel: connector 1)

2. Attach the antennas to the antenna out BNC connections (N connectors for MTK952N) (see rear

panel: connectors 8 and 13)

3. Connect the audio sources to the relative audio input connectors (see rear rear panel: connectors 7

for digital audio sources, connectors 9÷12 for analog audio sources)

NOTE: the cascade configuration allows to use the same analog audio input for more transmitter

4. Power on the MTK952

5. Switch off the RF output:

a. While the MTK952 is powering on and the progress bar appears, push the 3

button at

the bottom (see indication “OFF” on the display)

b. At the end of MTK952 power on, push the lower button on the right of the displays

6. Enter in the MAIN>Audio source menu and

a. configure the input parameter between digital and analog (according to the audio

source connected at point 3)

b. configure the AF level meter parameter as modulation

c. if digital audio source:

 leave audio gain left and right parameters to 0dB and adjust the audio level

with the mixer

 if need change the audio gain left and right parameters

d. if analog audio source:

 leave audio gain left and right parameters to 0dB and adjust Max audio level

parameter. NOTE: this parameters is unique for both the channels (right and

left)

 if need change the audio gain left and right parameters

NOTE: adjust the audio level (thru the mixer and/or Max audio level and/or the audio gain left

and right parameters) so that, for the maximum input signal level,

the AF level bars show the MAXIMUM

NUMBERS OF GREEN LED INDICATORS AND NO

YELLOW/RED CLIP LED INDICATORS

the MOD. (modulation) bar shows the

MAXIMUM NUMBERS OF GREEN LED

INDICATORS AND NO YELLOW/RED PEAK

LED INDICATOR

YES

7. Enter in the MAIN>Ch-Gr menu and set the group/channel/ frequency

8. Enter in the MAIN>Mode menu and set the appropriate Mode (see Compatibility table for more

detail)

9. Enter in the MAIN>TX Power menu and set the TX power (10÷200mW)

10. Exit from the menu and switch on the RF power output pushing the lower button on the right of the

display