User manual

rev.02
MTK952 User Manual
12
Options
This menu allows to change some parameters of the transmitter or display some information
Parameters
Range setting
Function
Name
ex. TRANSMITTER1
To change the name of the transmitter shown in the Status screen.
12 alphanumeric characters (A-Za-z0-9, case-sensitive)
DISPLAY brightness
0÷15 step 1
To set the brightness of the display
DISPLAY timeout
5÷60 step 5sec.
60÷120 step 10 sec.
To set the display timeout for:
 decrease the brightness of the display and
 return to Status screen
Info
IP address
ex. 192.168.10.1
to show the IP address
Serial
ex. R1825694
to show the serial number of the product
(the same indicated in the product label)
Range
ex. 470-800
to show the frequency range (MHz)
Temp. RF ampl.
ex. 30°C
to show the temperature took near the RF amplifier (°C)
Temp. RF gen.
ex. 31°C
to show the temperature took near the RF generator (°C)
Temp. micro
ex. 33°C
to show the temperature took near the RF microprocessor (°C)
Temp. pwr supply
ex. 31°C
to show the temperature took near the power supply (°C)
FW ver.
ex. 1.1
to show the firmware version (it sums up Boot+App+DSP versions)
Boot ver.
ex. 0.2.d
to show the bootloader version
App FW ver.
ex. 0.36.d
to show the application firmware version
DSP FW ver.
ex. 0.61.d
to show the DSP firmware version
Alarms
ex. 0
To show the number “n” of active alarms:
 n=0  0 active alarms
 n>0  n active alarms
When “n”>0, it is possible to enter in the alarm submenu which
allows to show the alarms list: a brief description and an alarm
code for each alarm.
For the complete list of alarms, see Alarm List section
Note: the complete software and hardware status is displayed on the MTK952 info screen