User manual

MPR30-IEM User Manual
Rev. 06

How to add a clone
Out mode
Balance
Equalizer
Vol boost
Pilot tone
Gr-Ch
Squelch
RX Name
How to load a clone
Use Clone>Load menu or UP/DOWN button (if the quick menu is configured to clone) to load a
clone. Afterwards push the arrows to change clone, SEL to activeted the clone and EXIT to exit
without changing.
Ex.
The configuration saved before the loading of the clone is saved on
the clone default, theref
allows to return with the previous settings. The following
arrows displayed near the clone number indicates the currently
clone loaded.
Clone name
Enable the IRDA interface on the RX from
which take the configuration (Infrared menu)
Enter in the Add menu and select the
wanted clone number. Then push SEL
to start the IRDA communication.
Put the receivers face
to face
At the end of the process the name
of the clone will be identify with the
name of the receiver.