User manual

MCR41-MCR42 User Manual

rev.10

HOW TO USE WISYCOM MCR4X MANAGER (V. 1.0.1 OR ABOVE)

Wisycom MCR4x Manager can be used to:

 Change the name of the receivers RX1 and RX2

 Change the name of the Presets

 Change name and description of the groups

 Assign a name and an Expander to a single channel

 Modify/load/save the channels memory

 Upgrade firmware

Instruction to connect MCR4x and UPK300E/UPK Mini:

1. Connect to the PC the infrared programming interface (UPK300E/UPK Mini) using a USB

cable (it is not possible to use IR interface of MRK950 or MRK960)

NOTE: the USB drivers must be installed on the PC, for further info check on the

Download area of the Programmers (UPKxx) on Wisycom website.

2. Check if the version of Wisycom Manager in your PC is the latest version otherwise

download the latest version from Wisycom website

(http://www.wisycom.com/www3/products/product/mcr42#4 ).

3. Run Wisycom Manager and then Wisycom MCR4x Manager

4. Power up the receiver MCR41/42 and enable the IRDA interface:

a. push button,

b. push button until that Infrared submenu appears on the display (Power

on>Edit RX1>Edit RX2>LINE mode>Display>Infrared)

c. push again button and check the display shows ‘IR IF active’

5. Put in front the IRDA interface of MCR41/42 to the UPK300E/UPK Mini