User manual

MCR41-MCR42 User Manual

rev.10

Advanced Menu

Headphones (only for BPA42-HPN)

Cycle through menu’s with up/down arrow to get your

desired configuration then confirm with SEL.

Volume: It is possible to set the desired output level from

Max (+6 dB) to min (-24 dB) in 1 dB step.

RX: Left and right channel of stereo jack can be mapped

respectively on RX1, RX2 or on RX1+RX2.

Signal: If set to LINE, on the headphones there is the same

signal of the output LINE. If set to TSQ>LINE and the Tone

Squelch is enable (Tone Squelch ON or ADV), on the

headphones it is possible to hear the signal even when the

Tone Squelch is not detected.

Power on (only for MCR42, not MCR41)

Allow to enable both the receivers:

Only receiver 1 (Rx1), only receiver (Rx2) or (Rx1 + Rx2).

Edit RX (MCR42 has the same menu for RX1 and RX2)

Selecting this sub-menu most of RX1 or RX2 setups are

configurable.

Edit RX: Name

Selecting Name, it’s possible to edit the name of the receiver

(12 characters). The number of visible characters in the

parameter Name depends on the type of characters used

(uppercase or lowercase characters).

Edit RX: GR-Ch

Select current group and channel.

Group name and channel frequency are displayed on the

right.