User manual

MTH400 User Manual

Rev.01

POWERING UP

Move the wireless power switch (fig. 3) in upper position (towards MIC body) to activate

wireless transmission: a green LED lights up (blinking when battery is low!).

SETUP CONTROL

Open MIC Body to access the “display and controls” area (fig. 1):

A. Graphics Display (OLED)

B. Channel selection buttons (ch)

C. MIC gain setup buttons (gain)

D. 3 position selector (up / down / click)

Fig. 4

OLED POWER UP (OLED IS IN OFF CONDITION)

Pushing down selector (click), the graphic display oled turns on.

At the beginning a <BOOT> menu is displayed, then <STATUS> menu enters automatically. In

order to keep the <BOOT> menu active, it is necessary to push and hold selector (click) for at

least 2 sec.

<BOOT> menu

In the <BOOT> menu it is possible to found information regarding the Hardware and Firmware.

- Model (MTH400)

- Band (ex. 1)

470-640

566-798

- Hardware revision (ex. 01)

- Firmware version (ex. 110 0E)

- Band in extended format (ex. 566-798

- Serial number (ex. R3827484)