LPM WLAN MiniCard LPM 1.0 module Naginata 1.1 LPM module 802.11 bgn Hybrid Switch Module Wistron 802.11 b/g/n Duplicity android switch Module User Manual Rev 0.1 2011.08.
LPM WLAN MiniCard FCC compliance Statement Federal Communication Commission interference state-ment this equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal-lation.
For Taiwan 警語： 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅 自變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象 時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信 法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫 療用電波輻射性電機設備之干擾。 Note: 1. 本模組於取得認證後將依規定於模組本體標示審驗合格標籤 2.
LPM WLAN MiniCard Table of contents CHAPTER 1 ........................................................................................................ 2 CHAPTER 2 ........................................................................................................ 2 CHAPTER 3 ........................................................................................................ 2 APPENDIX A ......................................................................................................
LPM WLAN MiniCard=rd Chapter 1 Introduction LPM module is a WLAN module with a BROADCOM single-chip BCM4319. The WLAN circuitry works with the host via the Secure Digital I/O (SDIO) interface. Being able to support the 802.11n standard in an 1x1 40MHz bandwidth mode, the data rates can be as high as 150Mbps. Features and Benefits • One Tiny Size Module Supporting Only takes a small 50.95 (W) x 30 (D) x 4.75(T) footprint. • Seamless Wireless Connectivity The modules support the IEEE 802.
LPM WLAN MiniCard What is Wireless LAN? Wireless Local Area Network (WLAN) systems offer a great number of advantages over traditional wired systems. WLANs are flexible and easy to setup and manage. They are also more economical than wired LAN systems. Using radio frequency (RF) technology, WLANs transmit and receive data through the air. WLANs combine data connectivity with user mobility. For example, users can roam from a conference room to their office without being disconnected from the LAN.
—Introduction LAN Modes Wireless LANs can be configured in one of two ways: Table 1: LAN modes Ad-hoc Networking Also known as a peer-to-peer network, an ad-hoc network is one that allows all workstations and computers in the network to act as servers to all other users on the network. Users on the network can share files, print to a shared printer, and access the Internet with a shared modem.
LPM WLAN MiniCard Chapter 2 Hardware Installation This chapter covers how to installing the Wireless card in your system. LPM module Hardware description The Wireless MiniCard has a SDIO interface for attaching to the system. And this module has IPEX connector to connect to external antenna.
LPM WLAN MiniCard Chapter 3 Using the Wireless Utility This module also come with a wireless utility, following describe how to use the utility. Configuration Utility for 802.11b/g/n To experience the IMM wireless, please make sure you have the Switch Manger installed. After you have the Switch Manger installed, IMM card will be ready for you to enjoy the wireless connectivity. 1. Select the “Home” option as below to enable IMM mode. 2.
LPM WLAN MiniCard 6. 7. 8. 9. Select “Wireless & networks” Click “Wi-Fi” checkbox to enable WiFi module. To connect to one WiFi access point, select “WiFi settings” for more options. Once you get IMM paired with one access point, IMM is ready to connect.
LPM WLAN MiniCard Appendix A Specifications Model Number LPM 1.0 1.1 module Naginata LPM module Product Type 802.11b/g/n wlan Module Interface(s) WC160/WC160M: SDIO Embedded MAC Address WU160M and WC160M only Main Chip(s) BCM4319 Package 68-pin LGA Wireless Standard(s) IEEE 802.11b/g/n Spreading IEEE 802.11b DSSS and 802.11g/n OFDM Operating Frequency 2412~2462MHz ISM band Antenna One antenna duplexing Tx and Rx Number of Channels 11 (US), 13 (EU), 14 (Japan) Data Rates 802.
LPM WLAN MiniCard j/31U.S. Regulatory Wireless Notice Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Appendix B Error Messages of Enabler Program This device is intended only for OEM integrators under the following conditions: . 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool.
LPM WLAN MiniCard . 3) For all products market in Canada, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change. As long as 23 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed.
Appendix B Error Messages of Enabler Program End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains IC: 4182A-LPM”.
