Installation Instructions

Low power license-exempt radio communication devices (RSS-247)
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference that may cause undesired operation of
the device.
When you use a wireless LAN/Bluetooth combo module in the 802.11 a/n transmission mode:
• The devices for the band 5150–5350 MHz are only for indoor usage to reduce potential for harmful
interference to co-channel Mobile Satellite systems.
• High power radars are allocated as primary users (meaning they have priority) of 5250–5350 MHz and
5650–5850 MHz and these radars could cause interference and/or damage to LE-LAN (Licence-Exempt
Local Area Network) devices.
Exposure of humans to RF fields (RSS-102)
The computer employs low gain integral antennas that do not emit RF field in excess of Health Canada limits
for the general population; consult Safety Code 6, obtainable from Health Canada's Web site at:
http://www.hc-sc.gc.ca/
The radiated energy from the antennas connected to the wireless modules conforms to the Canada Portable
RF exposure limit regarding IC RSS-102 Issue 5, Section 4 set forth for an uncontrolled environment, and are
safe for intended operation in the conventional setting. Further RF exposure reduction can be achieved if the
product can be kept as far as possible from the user body or set the device to lower output power if such
function is available.
Canada - Industrie Canada (IC)
Numéro de certification IC
Votre ordinateur contient les périphériques sans fil suivants et le numéro de certification IC indiqué ci-
dessous.
• IC: 4182A-AX201D2
– Carte combinée sans fil LAN/Bluetooth (modèle : AX201D2W)
• IC: 4182A-TP00111A
– TP00111A avec module sans fil WAN L850-GL
• IC: 4182A-TP00111AUC
– TP00111A avec module sans fil WAN T99W175
Vous trouverez les informations relatives aux numéros de certification IC via l'une des méthodes suivantes:
• Sur une étiquette physique apposée à l'extérieur du carton d'emballage de l'ordinateur
• Via un écran d'étiquette électronique (écran de l'E-label) préinstallé sur votre ordinateur
Pour accéder à l'écran de l'E-label, procédez comme suit:
• Redémarrez l'ordinateur. Lorsque l'écran d'accueil du logiciel s'affiche, appuyez sur la touche F9. L'écran
de l'E-label s'affiche.
Chapter 1. Regulatory information for users in USA and Canada 3