Data Sheet

SWA54 Module Datasheet Rev 1.2
9
1.4 Electrical Characteristics – RF PLL Characteristics
Operating Conditions: VDD =4.5 to 5.5V, TA = 0°C to +55 °C, RF Freq = 5150-5250;5725-5875MHz, measured relative to the RF balun
single-ended I/O. Typical specifications at T
A = 25°C, VDD = 5.0V
PARAMETER CONDITIONS MIN TYP MAX UNIT
RF Channel Frequency Range Band1(lower band) 5150 5250 MHz
Band4(Upper band) 5725 5875 MHz
RF Channel spacing 2 MHz
RF I/O Impedance ANT0,ANT1 50 ohm
Crystal Oscillator Frequency External crystal 16 MHz
1.5
Electrical Characteristics – RF RX Characteristics
Operating Conditions: VDD = 4.5 to 5.5V, TA = 0°C to +55 °C, RF Freq = 5150-5250;5725-5875MHz, measured relative to the RF balun
single-ended I/O. Typical specifications at T
A = 25°C, VDD = 5.0V
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNIT
RF Channel Frequency Range Band1(lower band) 5150 5250 MHz
Band4(Upper band) 5725 5875 MHz
RF I/O Impedance ANT0,ANT1 50 ohm
RX Sensitivity SSC (single sub-carrier) -89 *b dBm
DSC (double sub-carrier) -86 *b dBm
Max input signal LNA = low gain mode, min IF gain -5 dBm
Out-of-band blocker level <5150 MHz, >5850 MHz
2400-2483.5 MHz
-45
-20
dBm
dBm
Conductive 2
nd
harmonic
Main freq. : 5150-5250;5725-5875MHz
-61 dBm
*b : The sensitivity been defined with BER <= 0.002.
1.6
Electrical Characteristics – RF TX Characteristics
Operating Conditions: VDD = 4.5 to 5.5V, TA = 0°C to +55 °C, RF Freq = 5150-5250;5725-5875MHz, measured relative to the RF balun
single-ended I/O. Typical specifications at T
A = 25°C, VDD = 5.0V
PARAMETER
CONDITIONS
MIN
TYP
MAX
UNIT
RF Channel Frequency Range Band1(lower band) 5150 5250 MHz
Band4(Upper band) 5725 5875 MHz
RF I/O Impedance ANT0,ANT1 50 ohm
TX Output power*1 SSC (single sub-carrier) : 2MHZ OBW 14 dBm
DSC (double sub-carrier) : 4MHZ OBW 13 dBm
*1 : Skyworks has an application note “ATN-126 5 GHz bands for MAC 2.0” mentioned about band
setting for worldwide certification.